Water Wiggler Information

Items 4WW, 7WW and 8WW

Precautions

  • Water Seal: Always use the water seal in place. It is the large ring around the outer diameter of the unit, located between the plastic dome and plastic base.
  • Battery/Motor Compartment: Do not immerse in water or allow the unit to tip over in the birdbath.
  • Metal Legs: Always use with metal legs installed.
  • Debris: Keep algae, twigs, and leaves away from the stirrer to maintain battery life.
  • Water Level: Keep water level at least 1/4” below the plastic base.
  • Wet Compartment: If the battery/motor compartment gets wet, remove and dry the batteries and compartment.
  • Battery Replacement: Change batteries when the unit stops creating waves.
  • Winter Storage: Remove batteries and store the unit during winter to prevent freezing.

Directions

  1. Separate Dome and Base: Remove the screw on top of the dome to separate it from the base.
  2. Insert Wire Supports: Insert the 3 “U” shaped wire supports into the base.
  3. Attach Stirring Device: Press the stirring device into place on the motor.
  4. Insert Batteries: Insert two “D” cell batteries as indicated. The stirring device will start turning.
  5. Reattach Dome: Close the unit by reinstalling the screw on top of the dome.
  6. Water Level Check: Ensure the highest water level is at least 1/4” below the plastic bottom of the Water Wiggler. If necessary, raise the unit with a stable support.

Replacement of Stirring Floats

  1. Remove Stirrer Assembly: Take out the stirrer assembly from the bottom of the Water Wiggler.
  2. Replace Floats: Pull the wire guide out of the plastic crossbar, remove old floats, and place new floats on the wire guide.
  3. Reinsert Wire Guide: Insert the wire guide back into the crossbar and ensure it does not extend past the top edge.
  4. Remount Stirrer: Remount the stirrer to the Water Wiggler.